STMicroelectronics STM32WBA25HE→STM32WBA25HEF6TR
2.4 GHz Wireless Arm Cortex-M33 MCU, 64 MHz, 512 KB flash, Bluetooth BLE 6.2, Zigbee, Thread, 802.15.4, Q-SPI, USB OTG, TZ
The STM32WBA2xxx multiprotocol wireless and ultra-low-power devices embed a powerful and ultra-low-power 2.4 GHz RADIO compliant with the Bluetooth® LE specifications and with IEEE 802.15.4-2015. They contain a high-performance Arm® Cortex®-M33 32-bit RISC core. They operate at a frequency of up to 64 MHz. The devices integrate a 2.4 GHz RADIO supporting Bluetooth® LE, Thread®, and Zigbee®. It provides support for an array of up to eight antennas and an external power amplifier. The PTA (packet traffic arbitration) interface is supported. The Cortex®-M33 core features a single-precision floating-point unit (FPU), supporting all the Arm single-precision data-processing instructions and all the data types. This core also implements a full set of DSP (digital signal processing) instructions and a memory protection unit (MPU) that enhances the application security. The devices embed high-speed memories (512 Kbytes of flash memory and 96 Kbytes of SRAM), one Quad-SPI memory interface, and a range of enhanced I/Os and peripherals connected to AHB and APB buses on the 32-bit multi-AHB bus matrix. The devices offer a security foundation compliant with the TBSA (trusted-based security architecture) requirements from Arm.
Key features
- Includes ST state-of-the-art patented technology
- Ultra-low-power radio
- 2.4 GHz radio
- RF transceiver supporting Bluetooth® LE, IEEE 802.15.4-2015 PHY and MAC, supporting Zigbee®
- RX sensitivity: -96 dBm (Bluetooth® LE at 1 Mbps), -100 dBm (IEEE 802.15.4 at 250 kbps)
- Programmable output power, up to +10 dBm with 1 dB steps
- Support for external PA
- Packet traffic arbitration
- Integrated balun to reduce BOM
- Suitable for systems requiring compliance with radio frequency regulations ETSI EN 300 328, EN 300 440, FCC CFR47 Part 15, and ARIB STD-T66
- Bluetooth® LE
- LE 2M
- LE coded
- Direction finding
- LE power control
- Isochronous channels
- Extended advertising
- Periodic advertising
- LE secure connections
- LE audio
- Mesh networking
- Qualified against Bluetooth® Core 6.0
- Ultra-low-power with FlexPowerControl
- 1.71 to 3.6 V power supply
- -40 to 85/105 °C ambiant temperature range
- Autonomous peripherals with DMA, functional down to Stop 1 mode
- 110 nA Standby mode (7 wake-up pins)
- 490 nA Standby mode with 64-Kbyte SRAM
- 980 nA Standby mode with 64-Kbyte SRAM, 2.4 GHz radio, RTC
- 4.81 µA Stop 1 mode with 64-Kbyte SRAM, 2.4 GHz radio, RTC
- 21 µA/MHz Run mode
- Radio: Rx 3.58 mA/ Tx at 0 dBm 4.65 mA
- Core: Arm® 32-bit Cortex®-M33 CPU with TrustZone®, MPU, DSP, and FPU running at up to 64 MHz
- ART Accelerator: 4-Kbyte instruction cache allowing 0-wait-state execution from flash memory (frequency up to 64 MHz, 96 DMIPS)
- Benchmarks: 264 CoreMark® (4.12 CoreMark/MHz)
- Memories
- 512-Kbyte flash memory with ECC and 10 kcycles
- 96-Kbyte SRAM, including 32 Kbytes with parity check
- 512-byte (32 rows) OTP
- One Quad-SPI memory interface
- Power management: Embedded regulator LDO and SMPS step-down converter, supporting switch on-the-fly and voltage scaling
- Clock management
- 32 MHz crystal oscillator
- 32 kHz crystal oscillator (LSE)
- Internal low-power 32 kHz (±5%) RC
- Internal 16 MHz factory-trimmed RC (±1%)
- PLL for system clock, audio, USB, and ADC
- General-purpose input/output: Up to 27 I/Os (most of them 5 V-tolerant) with interrupt capability
- Analog peripherals (independent supply): 12-bit ADC 2.5 Msps, up to 16-bit with hardware oversampling
- Communication peripherals
- One USB full-speed selectable host or device controller
- One SAI (serial audio interface)
- One USART (ISO 7816, IrDA, modem)
- One LPUART (ISO 7816, modem)
- One SPI
- Two I2Cs Fm+ (1 Mbit/s), SMBus/PMBus®
- System peripherals
- Two 16-bit timers
- One 32-bit timer
- Two low-power 16-bit timers (available in Stop mode)
- Two SysTick timers
- RTC with hardware calendar and calibration
- One watchdog
- 8-channel DMA controller, functional in Stop mode
- Security and cryptography
- Arm® TrustZone® and securable I/Os, memories, and peripherals
- Flexible life cycle scheme with readout protection (RDP) and password protected debug
- Root of trust thanks to unique boot entry and secure hide protection area (HDP)
- Secure boot and secure firmware update
- AES accelerator
- Public key accelerator, ECC and RSA, SCA resistant
- HASH hardware accelerator
- True random number generator, NIST SP800-90B compliant
- 96-bit unique ID
- Antitamper protections
- Development support
- Serial wire debug (SWD), JTAG
- Embedded trace (ETM)
- All packages are ECOPACK2 compliant.
Applications
- Bluetooth Low Energy (BLE) sensors
- Wearables and health-monitoring devices
- Smart home accessories
- Industrial wireless peripherals
Do you have a Question?
Contact EBV
If you need any assistance, please click below to find your closest EBV sales office.
